Bgp4-mib download

Each peer negotiates the version from this vector. Versions are identified via the string of bits contained within this object. The first octet contains bits 0 to 7, the second octet contains bits 8 to This parameter can be used to restart BGP peer This object should be initialized to zero 0 when the connection is established.

This object should be initialized to zero when the connection is established. If no error has occurred, this field is zero. It is set to zero when a new peer is configured or the router is booted. An UPDATE message is used to advertise a single feasible route to a peer, or to withdraw multiple unfeasible routes from service.

Their contents represent routes that are available as an input to the Decision Process. SAFI values through are for private use. Hence that is used as the second index.

It gives additional information about the type of the route. An implementation is only required to support IPv4 address type Value - 1. An implementation is only required to support an IPv4 peer. Any bits beyond the length specified by cbgpRouteAddrPrefixLen are zeroed. The length is a 1-octet field containing the number of ASs in the value field. The value of this object is irrelevant if the value of of cbgpRouteMedPresent is false 2. The value of this object is irrelevant if the value of cbgpRouteLocalPrefPresent is false 2.

Time interval in seconds for the KeepAlive timer established with the peer. If the value of this object is zero 0 , it indicates that the KeepAlive timer has not been established with the peer, or, the value of bgpPeerKeepAliveConfigured is zero 0. The value ranges from 0 to This value must not be less than three seconds if it is not zero 0 in which case the Hold Time is NOT to be established with the peer.

The suggested value for this timer is 90 seconds. A reasonable maximum value for this timer would be configured to be one third of that of bgpPeerHoldTimeConfigured. The suggested value for this timer is 30 seconds. The suggested value for this timer is 15 seconds. The value set or obtained by the MIB depends on the value ranging from 0 to specified in the command line.

If the value specified in the command line is 0, the value is displayed as 1. Time interval in seconds for the MinRouteAdvertisementInterval timer. Each time bgpPeerInUpdates is incremented, the value of this object is set to zero 0. The recommended value is The value cannot exceed one third of the value of bgpPeerHoldTimeConfigured. The table has value only after peers are established.

The table describes the information about the routes to obtain the entire peer destination network. The value depends on the following two points:. The table has values only when the peer is not in the idle state. The sequence of AS path segments. The length is a 1-octet field containing the number of ASs in the value field.

The value ranges from 2 to in the MIB, but from 0 to in the command line. If the value specified in the command line is greater than , the value displayed in the MIB is This metric is used to discriminate between multiple exit points to an adjacent autonomous system. A value of -1 indicates the absence of this attribute. The value ranges from -1 to The value ranges from -1 to in the MIB, but from 0 to in the command line. The originating BGP4 speaker's degree of preference for an advertised route.

A value of zero 0 indicates the absence of this attribute. A value of 0. The degree of preference calculated by the receiving BGP4 speaker for an advertised route. The value scope is from -1 to