Advia 60 bayer manual




















Each sample was run in triplicate, followed by three background cycles. Page 23 3. Page Detergent : Sysklen 3. Caps of the sampling tubes Some caps of the sampling tubes are more adapted to "cap piercing" sampling systems.

Plastic caps cannot be used. Rubber caps can be of different quality materials. Use the best quality materials in order to avoid any rubber particles entering the sample tube when the cap is pierced. It is also recommended to use caps specially designed to avoid any blood retention in the upper part of the cap.

Page 27 3. Page 28 3. To obtain accurate hemoglobin results when increased turbidity of the blood sample occurs, determine the cause of the turbidity and follow the appropriate method below : 1. Page 29 3. The red blood cell dilution contains all of the formed elements in the blood : erythrocytes, leukocytes and platelets.

During the counting of the erythrocytes Red Blood Cells platelets are not included in RBC count since their size falls below the minimum threshold.

Page 30 3. The presence of agglutinated erythrocytes may be detected by observation of the abnormal MCH and MCHC values and by careful examination of the stained blood film. Chemotherapy - May also affect the sizing of PLTs. Page Chapter 4. Page Diluent And Lysing Action 4. Volumetric study After the differential lysing action, ADVIA analyzes the heights of each impulse, coming from the aperture and ranked in the counting channels.

A curve is obtained with number of cells on the y-axis and cell volume on the x-axis. A Red Cell Distribution Width RDW will enable you to follow the evolution of the width of the curve in relation to the cell number and average volume.

K SD With System constant Page Study Of General Flags 4. The result should be verified by repeating the sample or checked according to one of the laboratory reference methods.

Page Platelet Flags If this suspicious flag occurs more than three consecutive times run the checkup procedure. WBC Flags The ADVIA has a system of WBC differential flags alerting the operator to the possible presence of pathological cells, abnormal volume distribution histograms or abnormal elevated populations such as in the case of the eosinophils and basophils. As a result of the differential resistance of cytoplasmic membranes in the different cell types, pathological elements can be found in a number of different zones.

Page Chapter 5. Description Door to pneumatic part Piercing carriage door Front panel Diag. Before any attempt to remove the cover, open the pneumatic access door on the front of the system. Page B - Command Keys 5. Page 41 5. These 2 keys pressed simultaneously will allow an automatic adjustment of the LCD. Page Front Internal View 5. Page 44 5. Page Chapter 6. Wait for the end of the automatic startup cycle or press the STARTUP key, the instrument will perform a startup cycle and perform a blank cycle for a background count an analysis cycle on reagent without any blood sample.

Page Reagent Pack Sample collection should be done on venous blood by the means of vacuum or atmospheric sample collection tubes. B, B, and B, respectively. Refer to the package insert supplied with the control for instructions for use.

The identification menu is displayed : PAT. Page Standard Identification Mode 6. The following menu is displayed: RUN? Page Analysis 6. Analysis Install the sample tube in the tube holder and close the sample door to start the analysis if this mode has been selected or close the sample door and press the START key. Page Running Samples 6. Sample identification After completing the start up procedure, run a non pathological blood from the previous day, followed by the quality control analyses and then the sample analyses.

Page Results 6. Page Result Printout 6. Result printout 1. US mode Diag. Page 54 6. Standard mode Diag. Page Chapter 7. Calibration And Quality Control Calibration can be achieved in two different ways. Page Smart Card Option 7. Install the card in the smart card reader. Page Change Lot Number 7.

Maximize your workflow efficiency with gold-standard technology. With integrated and automated solutions from Siemens, you can scale from stand-alone instrumentation to complete automation as your productivity needs change. Intel Pentium E Dual Core 2. Due to regulatory reasons their future availability cannot be guaranteed.

Please contact your local Siemens Healthineers organization for further details. Unique cytochemical differentiation of myeloid and lymphoid cells, and six-parameter differential supplies additional clinical information Direct measurements of intracellular hemoglobin provide sensitive and specific RBC morphology for the accurate and early indication of disease states Accurate platelet counts in the clinically significant range excluding microcytic red cells and cell fragments minimize the number of manual counts and unnecessary costly platelet transfusions Further isolate and identify disease states without additional labor through CSF and CHr testing capabilities Maximize your workflow efficiency with gold-standard technology.

Data Management. General Specifications. ADVIA Contact Us. CentraLink Data Management System Standardize testing protocols and result management across your diagnostics network. Quality Control Management Improve the flow and value of information with web-based, laboratory management software tools. Page Connection Check 2. The advia 60 hematology system has been designed for effective operation in a variety of clinical settings. Closed tube sampling saves operator time, eliminates bio-hazard exposure.



0コメント

  • 1000 / 1000